How To Add Hydraulic Steering Fluid To A Boat

Owning a new boat ultimately brings the reality of performing both scheduled and nonscheduled maintenance. This doesn't take to exist onerous, though — have fun with these projects and make them an enjoyable part of your overall boating feel. One issue that you lot might encounter is a hydraulic gunkhole steering problem.

This diagram shows how to add hydraulic gunkhole steering fluid. Boating Magazine

In this situation, you'll demand to become some hydraulic-steering fluid that meets Mil-Spec H-5606C standards, such as Bounding main Star/Bay Star No. HA 5430; an adapter hose, like Ocean Star No. HA 5438; and a pushpin from the message board in your office. A rag also helps. Sea Star hydraulic steering fluid is prevalent in almost boating centers beyond the United states of america.

• Thread filler tube into helm pump
• Thread bottle of fluid onto filler tube
• Poke a hole into the lesser of the bottle (or, cut the lesser off and create a funnel)
• Plough bottle upside downwardly (like an IV)

Note: At all times, be certain there is fluid in the filler tube, if it drains out you are pumping air in the system and you will need to start over

How to Add Fluid to Hydraulic Steering

1. Thread filler tube into captain pump.
2. Thread bottle of fluid onto filler tube.
3. Poke a pigsty into the lesser of the bottle (or, cut the bottom off and create a funnel).
4. Turn bottle upside down (like an IV).
5. Turn steering bicycle hard to starboard.
6. Open starboard bleeder nipple located on the steering cylinder.
7. Turn steering wheel to the port side pumping air/fluid out of bleeder plumbing fixtures.
8. When an air gratis stream is seen, Close bleeder nipple.
9. Go along turning to the PORT side until engine comes hard over.
10. Open up port bleeder nipple located on the steering cylinder.
11. Plow steering wheel to the starboard side pumping air/fluid out of bleeder plumbing equipment.
12. When an air gratuitous stream is seen, Shut bleeder nipple.

The above volition ensure that you accept properly bled the system free and clear.

TIP–puncture the bottle on the bottom side, not the very lesser, with the pushpin. Doing and so enables you to place the pushpin back in and shop a partially-total bottle on a shelf without leaks.

How To Add Hydraulic Steering Fluid To A Boat,

Source: https://www.boatingmag.com/how-to/how-to-add-fluid-to-hydraulic-steering/

Posted by: wardposs1950.blogspot.com

Share this post